This web page refers to our older busTRACE 7.0 which is no longer shipping. Click here for details on our latest generation busTRACE software.

busTRACE This WEB page comes from the busTRACE 7.0 User's Manual. (Table of Contents)

Previous Topic Next Topic
 

Each purchase of busTRACE 7.0 comes with a custom busTRACE USB Flash Drive. The flash drive comes pre-installed with our busTRACE software. Simply insert the flash drive, go to the flash drive letter, and run our setup program you will find there.

As a licensee of busTRACE, you are allowed to use the software and flash drive on any computer you choose, including installing the software on multiple computers and moving the flash drive from system to system as needed. As the licensed user, however, you are the only user allowed to use the software and flash drive.

In order to use busTRACE 7.0, you will need to have the busTRACE flash drive installed on the target system. The exception to this is when you are doing a remote capture or running a capture client. If you are capturing I/O on a remote computer, the flash drive is not needed on that remote system (i.e. the server). Instead, it is only needed on the system that is connecting to the remote system (i.e. the client). In fact, the client system can connect and capture multiple server systems simultaneously. Refer to our Remote busTRACE Capture section for full details.