This web page refers to our older busTRACE 6.0 which is no longer shipping. Click here for details on our latest generation busTRACE software.

busTRACE 6.0 This WEB page comes from the busTRACE 6.0 User's Manual. (Table of Contents)

Previous Topic Next Topic
 

This section describes the Capture Settings configuration options available within busTRACE.

Startup Settings (All Devices)

busTRACE allows you to edit device capture settings on a per device basis. The settings available in this section allow you to configure the busTRACE default capture settings. Please refer to our Device Capture Parameters for descriptions of these options.

The Start busTRACE with capture enabled on all devices option is useful you want to have busTRACE launch with capture disabled on all devices. You can then simply place a checkmark on the device you are interested in capturing and start the capture process (if you are typically only interested in capturing I/O activity against one device).

Startup Settings (SRB/CDB Devices)

The settings available in this section allow you to configure the busTRACE default capture settings specific to SRB/CDB devices. Please refer to our Device Capture Parameters for descriptions of these options.

Load Startup Settings

If you have saved your preferred capture settings to file, you can configure busTRACE to auto-load the specified file at startup.

See Also: