This web page refers to our older busTRACE 6.0 which is no longer shipping. Click here for details on our latest generation busTRACE software.

busTRACE 6.0 This WEB page comes from the busTRACE 6.0 User's Manual. (Table of Contents)

Previous Topic Next Topic

This section describes the General configuration options available within busTRACE.

General Settings

Automatic tab selection

When you click on a captured I/O, the I/O Details pane will fill with analysis information for that specific I/O. In its default state, the I/O Details pane is comprised of several tabs such as Error Analysis, CDB 1 / CDB 2, Raw Data, and Data Structures.

By placing a checkmark on this option, you are configuring busTRACE to automatically select the tab that is likely the most useful. For example, if you click on an I/O that has failed, the Error Analysis tab would be selected. If you click on an I/O that successfully processed a CDB, the CDB 1 tab would be selected.

Removing the checkmark configures busTRACE to no longer auto-select the tab it thinks is the most useful.

Prompt to save capture buffer before new trace

When you start up a new local busTRACE capture, if there is unsaved data already in the capture buffer, you will be asked if you want to save the capture buffer prior to starting the new capture. If you do not want busTRACE to prompt you each time, simply remove the checkmark from this option.

WARNING: If you remove the checkmark from this option, you might inadvertently clear your capture buffer prior to saving to file.

Append storage "Device ID" in device tree

If we are able to determine a device's location (e.g. Target ID, LUN, etc.), we will append the location information after the device name if you place a checkmark on this option.

Append "Device Pointer" in device tree

Under Windows 2000 (and above), placing a checkmark on this field will show you the PDEVICE_OBJECT pointer value for each device in the device tree. Under Windows Me, the DCB pointer will be shown. This is an advanced feature intended for kernel driver writers who require this level of information.

Startup Settings

Show "Tip of the Day" at startup

You can enable or disable our showing of a "Tip of the Day" dialog box each time you run busTRACE.

Automatically launch busTRACE when Windows starts

You can configure busTRACE to automatically launch each time Windows starts.

Automatically start capture when busTRACE starts You can configure busTRACE to automatically start capturing I/O activity when busTRACE starts.

See Also: