busTRACE This WEB page comes from the busTRACE 10.0 User's Manual. (Table of Contents)

Previous Topic Next Topic
 

This section describes the I/O Handling configuration options available within busTRACE.

These settings allow you to configure which parts of an IRP busTRACE will display NUMA Node information for. This is only applicable for systems with multiple NUMA nodes.

NUMA Node Display Options

Display Device NUMA Node Display the device the NUMA node is connected too (if known to Windows)
Display Processor NUMA Node Display the processor executing the IRP (going down and up the I/O stack)
Display IRP NUMA Node Display the NUMA node the IRP is stored in
Display I/O Stack NUMA Node Display the NUMA node the I/O stack is stored in
Display SRB NUMA Node Display the NUMA node the SRB/ExSRB is stored in
Display URB NUMA Node Display the NUMA node the URB is stored in
Display IOCTL NUMA Node Display the NUMA node the IOCTL data buffer is stored in
Display MDL NUMA Node Display the NUMA node the Memory Descriptor List (MDL) scatter/gather list points too

See Also: